Panasonic AG-BS300P Operating Instructions Manual page 16

List of Menus (continued)
<DOWNCON SETTING>
Item / Data Saved Variable Range
MODE SQUEEZE
S-CROP
LT-BOX
DETAIL ON
OFF
DETAIL LEVEL 0
8
31
CORING 0
5
15
2D LPF ON
OFF
SET UP 0%
7.5%
Set the mode for the composite signal output from the VIDEO OUT terminal.
SQUEEZE: Video will be squeezed horizontally.
S-CROP: Video will be cropped on both sides.
LT-BOX: Video will be squeezed vertically.
Set the ON/OFF of the detail function of the composite signal output from the VIDEO
OUT terminal.
ON: Detail signal will be added.
OFF: Detail signal will not be added.
Detail component that was set during the HD signal processing of the camcorder is
included in the composite signal output from the VIDEO OUT terminal.
This setting will superimpose the detail signal of the composite signal output from the
VIDEO OUT terminal on the signal from the camcorder.
Detail signal that was added during the HD signal processing cannot be turned OFF
even if this setting is turned OFF.
Set the level of the detail component for the composite signal output from the VIDEO
OUT terminal.
Set the level of the noise elimination level included in the detail component for the
composite signal output from the VIDEO OUT terminal.
Perform the setting of the 2D low-pass filter which will reduce the cross-color.
ON: Reduction of cross-color is performed.
OFF: Reduction of cross-color is not performed.
Perform the setting of the setup level against the composite signal output from the
VIDEO OUT terminal. (Only for 1080/59.94i)
0%: Setup level is 0 %.
7.5%: Setup level is 7.5 %.
Setup level will become 0 % when the system frequency is 50 Hz.
Note
16