Other Functions; Attachment Hub; Adjusting The Attachment Shaft; Turn The Speed Selector - Electrolux EKM4000R Instruction Manual

Getting started
7. LED working light (K) and LED
power indicator light (C): If the
appliance is plugged in and a speed is
selected, a blue LED lights up around
the speed selector (B).
A working light will also light up over
the working area. If the speed selector
(B) is moved to "OFF", the LED working
light (K) will automatically shut off
after 3 min.

Other functions

1. Attachment hub (L): The appliance
comes with a built in multi-purpose
attachment hub (L). Read and
carefully follow the instructions
that come with each attachment for
correct and safe use.
8. Note: If the speed selector (B)
is already turned on before the
appliance is plugged in, both the LED
power indicator light (C) and the LED
working light (K) will flash on and off
to let you know the speed selector
(B) has been left on. Turn the speed
selector (B) to "OFF" and the lights will
stop flashing. Then resume operating
normally.

2. Adjusting the attachment shaft

(J): The appliance is adjusted at the
factory so that the flat beater (Q)
clears the bottom of the bowl (H,T). If
the flat beater (Q) hits the bottom of
the bowl or is too far away from the
sides, you can adjust it correctly. See 3
for further instructions.
3. Turn the speed selector (B) to "OFF"
and unplug the appliance. Tilt the
motor head (A) back. Use a slotted
point head screwdriver to adjust the
screw. Turn anti-clockwise to raise the
attachment shaft (J), turn clockwise to
lower it.
EN
5