Hydraulic Unit; 3-Point Hitch Control System; Position Control; Float Control - Kubota M5660SUH Operator's Manual

48

HYDRAULIC UNIT

HYDRAULIC UNIT
The standard tractor has following hydraulic control
systems as shown below. Therefore, use the most
appropriate system for the implement you are using.
C 3-Point Hitch Control System

1. Position Control

2. Float Control

C Remote Hydraulic Control System
A Do not operate until the engine is warmed up. If
operation is attempted when the engine is still cold, the
hydraulic system may be damaged.
A If noises are heard when implement is lifting after the
hydraulic control lever has been activated, the
hydraulic mechanism is not adjusted properly. Unless
corrected, the unit will be damaged. Contact your
KUBOTA Dealer for adjustment.

3-POINT HITCH CONTROL SYSTEM

To avoid personal injury or death:
A Before using the 3-point hitch controls, ensure
that no person or object is in the area of the
implement or 3-point hitch. Do not stand on or
near the implement or between the implement
and tractor when operating the 3-point hitch
controls.
BPosition Control
C Hydraulic control lever
This will control the working depth of 3-point hitch
mounted implement regardless of the amount of pull
required.
(1) Position control lever
BFloat Control
Place the position control lever in the float position to
make the lower links move freely along with the ground
conditions.
B3-point Hitch Lowering Speed
To avoid personal injury or death:
A Fast lowering speed may cause damage or
injury. Lowering speed of implement should be
adjusted to 2 or more seconds.
The lowering speed of the 3-point hitch can be controlled
by adjusting the 3-point hitch lowering speed knob.
(1) 3-point hitch lowering speed knob
(A) "FLOAT"
(B) "DOWN"
(C) "UP"
(A) "FAST"
(B) "SLOW"
(C) "LOCK"