Kubota M5660SUH Operator's Manual page 43

6. Insert the key into the key switch and
turn it "ON".
"OFF" "ON"
C Check Easy Checker(TM) Lamps:
1. When the key is turned "ON", lamps (2) (3) should
come on. If trouble should occur at any location while
the engine is running,
corresponding to problem will turn "ON".
2. Suppose that the engine coolant temperature is not
high enough yet. The heater indicator (4) also turns
"ON" when the key is turned "ON" to preheat the
engine and goes off automatically when preheat is
completed.
Illumination time of indicator varies according to the
temperature of coolant.
3. The PTO clutch indicator (1) comes on while PTO
clutch control lever is engaged "ON" and goes off
when disengaged.
4. If the fuel level indicator (5) lights up, when fuel level is
very low, therefore add fuel and the light will turn
"OFF".
5. If the parking brake warning indicator (6) does not
illuminate, set the parking brake.
"START"
the indicator lamp
OPERATING THE ENGINE
(1) PTO clutch indicator
(2) Electrical charge warning
indicator
(3) Engine oil pressure warning
indicator
A Some of the Easy Checker(TM) lamps may illuminate
or start flashing depending on the positions of the
levers and switches.
A Daily checks with the Easy Checker(TM) only, are not
sufficient. Never fail to conduct daily checks carefully
by referring to Daily Check. (See "DAILY CHECK" in
"PERIODIC SERVICE" section.)
7. Fully depress the clutch pedal.
8. Turn the key to "START" position and
release when the engine starts.
A Because of the safety devices, the engine will not start
except when the PTO clutch control lever is placed in
the "OFF" position and shuttle shift lever is placed in
the "NEUTRAL" position.
9. Check to see that all the lamps on the
Easy Checker(TM) are "OFF".
If a lamp is still on, immediately stop the engine and
determine the cause.
10. Release the clutch pedal.
21
(4) Heater indicator
(5) Fuel level indicator
(6) Parking brake warning
indicator
(7) Key switch