Wiring Connection - Kenwood KDC-BT610U Instruction Manual

INSTALLATION/CONNECTION

Wiring connection

IMPORTANT : We recommend installing the
unit with a commercially available custom
wiring harness specific for your car and leave
this job to professionals for your safety.
Consult your car audio dealer.
To front speaker (left)/
For 3-way crossover: Mid range speaker (left)
To front speaker (right)/
For 3-way crossover: Mid range speaker (right)
To rear speaker (left)/
For 3-way crossover: Tweeter (left)
To rear speaker (right)/
For 3-way crossover: Tweeter (right)
Ignition switch
Car fuse box
Car fuse box
Black (Ground wire)
To the metallic body or chassis of the car
Battery
Rear/Front/Subwoofer output
For 3-way crossover: Tweeter/
Mid Range/Woofer output
Antenna terminal
Fuse (10 A)
White/Black
Gray/Black
Green/Black
Purple/Black
Red (Ignition wire)
Yellow (Battery wire)
Rear/subwoofer output
For 3-way crossover:
Woofer output
Microphone input jack ( 11)
White
If no connections are made, do not let the wire come
Gray
Brown
(Mute control wire)
Green
Purple
Blue/White
(Power control wire/
Antenna control wire)
(12 V 350 mA)
Light blue/yellow
(Steering remote control
wire)
When connecting to an external
amplifier, connect its ground wire to the
car's chassis to avoid damaging the unit.
out from the tab.
To connect the Kenwood
navigation system, refer your
navigation manual
To the power control terminal
when using the optional power
amplifier or to the antenna control
terminal in the vehicle
To the steering wheel remote
control adapter
ENGLISH
31