ELECTRO FREEZE cs5 Operator's Manual page 58

Look through top hole Look through top hole in
in tube — you should tube — you should see the
see clear through. inner white plastic tube
(regulator) blocking the
opening.
MIX LEVEL LINE
Closed — empty hopper
Closed — mix at level line
PRIMING THE FREEZER
Open — full hopper
1. Make sure that your hands and forearms and
all freezer assemblies are sanitized.
2. Install the mix feed tube assembly in the
hopper. Push all the way down and make
sure the regulator is in the "CLOSED"
position.
3. Fill the hopper with mix to the mix level line
on the mix tube assembly.
4. Place an empty container under the dispense
head. While holding the plunger open, place
the regulator in the "OPEN" position, and
allow the mix to force out all remaining
sanitizer. When pure mix appears, close the
plunger.
5. Remove the mix feed tube and allow the
remaining mix in the hopper to flow into the
cylinder.
6. Reinstall mix feed tube assembly in the
hopper and push all the way down. Make
sure the regulator is in the "CLOSED"
position.
Important:
Failure to completely remove sanitizer or
water from the freezing cylinder before
placing in "AUTO" will damage the
freezer.
7. Turn selector switch to "AUTO" to begin the
freezing process. Fill the hopper with mix
AND install hopper cover.
8. Keep the regulator in the "CLOSED" position
until you are ready to dispense the first
serving. When ready, approximately 15-20
minutes, move regulator to the "OPEN"
position.
9. During long idle periods, the regulator should
be closed — but remember — when dis-
pensing product, make sure that the mix
feed regulator is open at all times. If not
open, the flow of mix will be restricted caus-
ing the product to freeze up. This condition
could cause damage to the freezer. Do not
allow lubricant or frozen product to block the
hole in the tube, as this will have the same
result.
®