Installing The Elite Series Sliding Server Shelf (Rm400); What's Included; Installation - Black Box 525068 User Manual

ELITE SERIES DATA CABINETS
8. Installing the Elite Series Sliding
Server Shelf (RM400)

8.1 What's Included

• (4) Mounting brackets
• (1) Shelf assembly
• (8) #10-32 screws
• (12) Wing nuts

8.2 Installation

1. Remove the shelf tray from the assembly by holding the cable support bar and pulling the shelf out. There
is a slide release tab on each side. Push the tabs in and pull the shelf tray out of the assembly.
2. Mount the server fins on the shelf tray. The studs on the bottom of the fins should be placed in the long
slots on the top of the shelf tray; use wing nuts to secure them underneath the shelf tray. Use four fins for
two servers or two fins for one large server.
3. Mount the remaining part of the shelf assembly to the mounting rails (at the desired height) using two 10-
32 screws per bracket. Do not tighten the screws.
4. Slide the shelf tray back onto the mounted portion of the assembly so that the slide locks to the shelf.
Tighten the screws on the mounting brackets once the shelf tray is secured back in the assembly.
5. Attach the cable bridges to the rear slot on the shelf tray using two wing nuts (included) and two
lockwashers (not included) per bridge.
Server fins
Shelf tray
16
Figure 14. Sliding server shelf.
Cable bridge
Cable
support
bar