Adjusting Rails Front To Back; Cable Access - Black Box 525068 User Manual

ELITE SERIES DATA CABINETS

7.3 Adjusting Rails Front to Back

The rails can be adjusted easily from front to rear in one-inch increments by removing the two
bolts (Figure 12) from the top and bottom support brackets and repositioning as desired.

7.4 Cable Access

The Elite Series Data Cabinet is furnished with a variety of cable-entrance/exit ports. The top of the cabinet is
removable for top cable access. The bottom cover plate is removable for bottom cable access. Two (for the 48",
60", 72", 78", and 84" models) or four (for the 30" models) 1.75" diameter ports are located on the top rear
frame member and two are located on the rear bottom frame member. These ports can be used for conduit,
power cord exit, etc. The rear of the cabinet also features two large cable-access cutouts below the rear door
that can be used by removing the two 6-32 pan-head locking screws that secure the cover plates. The standard
accessory kit provided inside the enclosure contains 60 inches (152.4 cm) of rubber edge guard that can be
applied to the metal edges on any of the cable-access ports to protect your cables.
14
Figure 12. Adjusting the rails.
Mounting rail
1
⁄ -20 Hex-head bolt
4
Adjustable
bracket
1
⁄ -20 hex head
4