JVC RX-8040B Instructions Manual page 56

CONNECTIONS 3: Video Cable Connection
This receiver is equipped with three types of the video terminals—S-video, composite video, and component video, and can output the signal
through the output jack only the signal came from same type input jack. So you need to connect the VCR 1 and/or DVD player to the TV
using one of the following three ways:
• When using the AV COMPU LINK remote control system, set the component video input for the VCR 1 (VCR connected to the
VCR 1 jacks) and DVD player correctly (see "Setting the component video input" on page 38); otherwise, the correct input for this
receiver will not be selected on the TV.
When connecting the source equipment to the receiver through the S-video jacks, connect the receiver
to the TV's Video Input 1 jack (S-video input) using S-video cables.
Source
CASE 1
Equipment
When connecting the source equipment to the receiver through the composite video jacks, connect
the receiver to the TV's Video Input 2 jack (composite video input) using composite video cables.
CASE 2
Source
Equipment
When connecting the source equipment to the receiver through the component video jacks, connect
the receiver to the TV's Video Input 2 jack (component video input) using component video cables.
CASE 3
Source
Equipment
The AV COMPU LINK remote control system allows you to use the
five basic functions listed below.
Remote Control of the VCR, DVD player, and TV
using This Remote Control
IMPORTANT:
To operate the video components using the IR signal transmitter
(supplied), place it so that it is aimed at the remote sensor(s) on the
target video component(s).
• The IR signal transmitter can send signals at a distance of 3 m.
TV
This receiver
You can control the connected video components using this remote
control. Aim the remote control at the remote sensor(s) on the target
video component(s) or on the receiver directly.
For details, see page 58.
Note:
To operate the video components from Zone 2, use the RF rod
antenna and IR signal transmitter (see pages 14 and 15).
54
This receiver
S-video cable
This receiver
Composite
video cable
This receiver
Component
video cable
One-Touch Video Play
• Simply by inserting a video cassette without its safety tab into the
VCR 1 (VCR connected to the VCR 1 jacks), you can watch the
video playback without setting other switches manually.
The receiver automatically turns on and changes the Zone 1
source to "VCR 1."
The TV automatically turns on and changes the input mode to the
appropriate position so that you can view the playback picture.
When you insert a video cassette with its safety tab in place, press
the play (3 3 3 3 3 ) button on the VCR or on its remote control. Thus,
you can get the same result.
– If the receiver is already turned on with the ZONE 2 indicator
DVD player
DVD
• When you press PLAY on the remote control supplied for this
VCR 1
receiver for operating the VCR 1, the receiver automatically turns
on and changes the Zone 1 source or Zone 2 source to
"VCR 1"—depending on ZONE 1/ZONE 2 selector setting on the
remote control.
– For Zone 1 operations only: The TV automatically turns on and
S-video cable
Composite
video cable
Component
video cable
lights up and the source name for Zone 2 appears on the unit's
display, the receiver changes the Zone 2 source to "VCR 1."
changes the input mode to the appropriate position so that you
can view the playback picture.
TV
To Video Input 1
TV
To Video Input 2
TV
To Video Input 2