JVC RX-8040B Instructions Manual page 13

Cassette deck
You can connect either a cassette deck or an MD recorder to the
TAPE/MD jacks. When connecting an MD recorder, see below.
Cassette deck
To audio input
Right / Left
OUT
(REC)
R
TAPE
/ MD
L
IN
(PLAY)
MD recorder
You can connect either an MD recorder or a cassette deck to the
TAPE/MD jacks. When connecting a cassette deck, see above.
MD recorder
To audio input
Right / Left
OUT
(REC)
R
TAPE
/ MD
L
IN
(PLAY)
Note:
When connecting an MD recorder to the TAPE/MD jacks, change the
source name to "MD," which will appear on the display when it is
selected as the source. See page 24 for details.
Video component connections
Use the cables with RCA pin plugs (not supplied).
Connect the white plug to the audio left jack, the red plug to the
audio right jack, and the yellow plug to the video jack.
• If your video components have S-video (Y/C-separation) and/or
component video (Y, P
video cable (not supplied) or component video cable (not
supplied). By using these jacks, you can get better picture quality
in the order:
To audio output
• If your video components have digital audio output terminal,
connect them using the digital cords explained in "Digital
connections" (see page 14).
If your video components have an AV COMPULINK jack
See also page 53 for detailed information about the connection
and the AV COMPULINK remote control system.
L
IMPORTANT:
R
This receiver is equipped with the following video jacks—composite
video, S-video and component video jacks. You can use any of the
three to connect a video component.
However, the video signals from one type of these input jacks are
transmitted only through the video output jacks of the same
type.
Therefore, if a recording video component and a playing video
component are connected to the receiver through the video jacks of
different type, you cannot record the picture. In addition, if the TV and
a playing video component are connected to the receiver through the
video jacks of different type, you cannot view the playback picture on
the TV.
Video camera
To audio output
The VIDEO input jacks on the front panel (inside the front door) are
convenient when connecting and disconnecting the component
frequently.
L
R
DIGITAL
Note:
When using the digital input terminal, select the digital input mode
correctly. For details, see "Selecting the Analog or Digital Input Mode"
on page 22.
, P ) terminals, connect them using an S-
B R
Component video > S-video > Composite video
L R
S-VIDEO VIDEO L—AUDIO—R
VIDEO
Video camera
To audio output
To composite video
output
To S-video output
To optical digital output
11