Wiring Connection - JVC KD-X130M Instruction Manual

Wiring connection

Signal cord
(not supplied)
JVC Amplifier * 1
Fuse (10 A)
Remote wire
(not supplied)
Ignition switch
Car fuse block
Separate red wire
Make this connection if your
vehicle factory wiring harness
does not have "12 V ignition
switch" wire.
* 2
You can also connect a
subwoofer speaker directly
using this lead without an
external subwoofer amplifier.
For setting, 10.
Front output
Rear/subwoofer output
Antenna terminal
Light blue/yellow
STEERING
WHEEL
REMOTE
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
Brown: Tel muting
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
2
Green: Rear speaker (left) *
2
Green/black *
IMPORTANT
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult your
car audio dealer.
To the steering wheel
remote control adapter
Blue: To power antenna
Blue/white: To amplifier
Recommended connection
* 1
Firmly connect the ground wire
of the amplifier to the car's
chassis to avoid damaging the
unit.
Part list for
installation
(A) Faceplate
Vehicle
dashboard
Factory wiring
harness (vehicle)
(B) Trim plate
Custom wiring harness
(separately purchased)
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
ENGLISH
15