Firmware Update - Mutable Instruments ambika User Manual

Ambika – User manual | Mutable Instruments
36 of 44
leds: Disables the voicecard LEDs, in case you consider that synths should not be used as Diwali
decorations. Note that you need to reboot the unit for this setting to take effect!
auto (auto backup): Enables or disables the backup copy created on the memory card whenever an
item is overwritten. Disabling it will make saving faster.
It is also possible to save the current multi so that it is reloaded every time Ambika starts up. This is
very useful for saving your MIDI settings and favorite split/voice allocation parameters!
pt 1 program .A000 junon
pref|>ini|about
On this library page, press S2 to select the ini command.
(?) use current multi as default?
Press S7 to confirm. The unit will freeze for a few seconds to write the current multi to its non-volatile
memory.

Firmware update

Firmware update through the SD-card
From the library page:
pt 1 program .A000 junon
| init|send|save|versions
Press S7 to display more commands:
pt 1 program .A000 junon
pref|>ini|about
Press S3 to bring the about page:
ambika v1.0|port 1 device 1
http://mutable-instruments.net/ambika/manual
more|exit
yes | no
more|exit
more|exit
v1.0
2/17/17 4:58 PM