Mutable Instruments ambika User Manual page 33

Ambika – User manual | Mutable Instruments
33 of 44
Turn the encoder to select a bank.
Click the encoder when you are done.
Reinitializing programs/multis/sequences/patches
Press S2 (*init* command) to reinitialize or randomize the select object. This brings the following
confirmation page:
pt 1 program
Turn the encoder to select an action (randomize will replace all settings by random values; while
initialize will replace all settings by the values they had at startup). Press S7 to confirm, or S8 to
cancel the initialization.
Dumping programs/multis/sequences/patches as SysEx
Press S3 (*send* command) on the library page to send the selected object on the MIDI output,
encoded in SysEx messages. Note that programs are sent as 2 messages (1 block with synthesis
settings and 1 block with part settings) ; and multi are sent as 13 messages ; so you need to set your
SysEx Librarian program to receive many messages.
Saving programs/multis/sequences/patches
After having selected with S1 which object type you want to save (multi, program, etc.), press S4
(*save* command).
pt 1 program .A000 junon
Before saving a program/multi/sequence/patch, its bank letter, number and name must be set. Use
the encoder to increment/decrement the value or letter at the cursor. To move the cursor, click the
encoder, turn it to move the cursor, and click it again.
When you are done, press S7 (*save* command). If you want to cancel the operation, press S8
(*cancel* command).
A warning will be displayed in case the memory card is damaged, full, incorrectly formatted, or just
http://mutable-instruments.net/ambika/manual
[ randomize ]
yes | no
save|cancel
2/17/17 4:58 PM