Dash Layout; Navigation Lights - Quicksilver 810 Arvor Owner's Manual

Quicksilver 810 Arvor — General Information

10. Dash Layout

Please note that operator vision from the helm may be obstructed by high trim angles of the craft,
along with other factors such as hull trim plane angles, loading and load distribution, speed & acceler-
ation, transition from displacement to planing mode, sea conditions, rain and spray, darkness and fog,
interior lights, position of tops and curtains, and persons or movable gear in the operator's field of
vision.
Dash Switch Panel

11. Navigation Lights

Your boat comes equipped with navigation lighting for use at night or in low visibility conditions. Prior
to running at night, make sure that the all around light located on the hardtop is in the upright
position. There are two switches, located on the helm switch panel, that controls these lights. To turn
on the Navigation Lights, push the upper part of the left switch forward to illuminate the port (red)
and starboard (green) bow lights, and push the upper part of the right switch forward to illuminate
the all around light (white) showing other vessels that you are underway. To turn on the Anchor Light,
only push the upper part of the right switch illuminating the all around light (white), letting other
boaters know that you are anchored at a given location.
GPS
SmartCraft
Stereo
12V outlet
USB receptacle
Helm switches
Steering wheel
Bow thruster control
Trim tab switches
Fire extinguisher override
Windlass switch
Trolling valve control
Engine throttle shift control
Bow navigation lights
Anchor light
Lighting
Fresh water pump
Bilge pump
Bilge pump
Port wiper
Starboard wiper
9
TM
gauges