Table of Contents
Advertisement
Registration
The procedures described below are the procedures that you will find in your SE630 handset. The procedures
may vary according to the handset you want to register. In this case, please refer to the manufacturer of the
additional handset.
Additional handsets must be registered to the base unit before you can use them. Up to 5 handsets can be
registered to one base station.
The Master PIN is required before you can register or unregister handsets. The default PIN is 0000.
To register an additional handset
1.
On the base station, press and hold
procedure has to be done within 1 minute.
Within 1 minute, the base station is able to accept registration from a handset. If no key is pressed
within 10 seconds, the registration procedure will be aborted.
2.
At the same time, on the handset, press
:
Registration
scroll
to
3.
Enter the Master PIN when prompted and press
:
4.
Press
to select the Base to be registered to and press
If the base is found and the PIN is correct, the unused handset numbers will be displayed and you can
select a handset number by entering the number directly.
If the PIN is incorrect,
A long confirmation tone is emitted to indicate successful registration and the screen returns to stand-by
mode.
Select Base
One SE630 handset can register up to 4 different SE630 Base stations. By default, the handset will register to
Any
BASE 1. If you select
To manually select a base station
m
1.
Press
MENU
, scroll
m
SELECT
.
:
2.
Scroll
to the desired base station and press
3.
The handset will start searching for the base station. If the selected base is found, a long confirmation tone
is emitted.
Advanced Settings
c
for 3 seconds in stand-by mode. After that, the registration
m
MENU
m
and press
SELECT
Incorrect PIN
will be displayed and the handset returns to stand-by mode.
Base, the handset will register to the nearest base station.
:
Advanced Set
to
:
, scroll
to
Advanced Set
.
m
to start registration.
OK
m
OK
to confirm.
m
press
SELECT
, scroll
m
to confirm.
OK
m
and press
SELECT
:
Select Base
to
and press
EN
,
43
Advertisement
Table of Contents
