Waeco MagicSpeed MS900 Installation Manual page 29

MagicSpeed
7.2 Laying and connecting the cable
You will find a summary of the wiring in fig. d, page 9.
No. Component
1 Electronic module
2 Diagnostic plug
3 Main wiring harness
4 Vehicle CAN bus wire
Connecting the wiring harness for the CAN bus
Disconnect the battery.
Pull the plug protector (fig. 6 2, page 5) off the diagnostic plug (fig. 6 2,
page 5).
The wires can now be disconnected with a screwdriver (fig. 6 A,
page 5).
Connect the blue wire of the CAN bus wiring harness (fig. 7, page 5):
– Disconnect the purple/red wire (1) from socket 14 of the diagnostic
plug
– Connect the purple/red wire (1) to the blue wire (2) of the CAN bus
wiring harness
– Protect the connection using an insulating sleeve (3)
– Connect the blue wire (4) of the CAN bus wiring harness to socket 14
of the diagnostic plug
Connect the pink wire of the CAN bus wiring harness (fig. 8, page 6):
– Disconnect the white/red wire (1) from socket 6 of the diagnostic plug
– Connect the white/red wire (1) to the pink wire (2) of the CAN bus wir-
ing harness
– Protect the connection using an insulating sleeve (3)
– Connect the pink wire (4) of the CAN wiring harness to socket 6 of the
diagnostic plug
Connecting the electrical power to MagicSpeed
No.
5
6
7
8
Component
Main wiring harness con-
nection
CAN bus connection
Control element connection
ESP switch
29