Waeco MagicSpeed MS900 Installation Manual page 27

MagicSpeed
6.2 Fitting the electronic module
Note
I
When selecting the installation location, observe the following in-
structions:
Install the electronic module
– Near the CAN-Bus diagnostic plug
– Not anywhere subject to heat or moisture
– Not in the engine compartment
– Not near high-voltage components
– Not directly next to ventilator nozzles
Where possible, use existing holes in the vehicle.
Caution
a
Before drilling holes, make sure the bit will not damage anything on
the other side (fig. 2, page 3).
Select a suitable installation location (fig. 5, page 4).
Note
I
The electronic module can be attached to the vehicle using the
screws supplied or double-sided adhesive tape.
Temporarily mount the electronic module at the selected position.
Do not fasten the electronic module before you have decided where to
lay the cables.
After finishing the electric wiring, fasten the module in the selected posi-
tion:
– Fasten the electronic module using double-sided tape or ...
– Mark the holes for installation.
– Drill two holes with 3 mm diameters.
– Tightly fasten the electronic module using the screws provided.
MagicSpeed installation
27