EMAK 102 Operator's Manual page 116

NOTE
If you have to replace one or both rear
wheels, make sure that any differences in their external diam-
eter does not exceed 8-10 mm; on the contrary, to prevent an
uneven cut it will be necessary to adjust the alignment of the
cutting deck.
IMPORTANT
Before remounting the wheel, apply
grease to the axle. Put the snap ring (1) and supporting wash-
er (2) back in place.
6.3.4 Replacing and repairing the tyres
The tyres are "Tubeless" and so all punctures must be repaired
by a tyre repairer following the procedures required for this kind
of tyre.
6.3.5 Replacing the bulbs (if present)
The bulbs (18W) have a bayonet fitting and are installed in the
bulb holder which can be taken out by turning it anti-clockwise
with pliers.
6.3.6 Replacing a fuse
The machine is fitted with fuses (1) with different capacities and
functions. Specifically:
– 10 A fuse = protects the main and power circuits of the elec-
tronic circuit board. When it blows, the machine stops and the
dashboard light switches off.
– 25 A fuse = protects the battery charger circuit. When it
blows, the battery gradually runs out and the machine will
have problems starting.
Electric tipping
– 15A fuse = pro-
tects the control
motor circuit. If it
trips, the tipping
system stops
working electri-
cally, so you can
empty the grass-
catcher using
the manual lever
(if fitted).
1
The fuse capacity is
indicated on the fuse.
1
EN 33