Testing Communication - Interlogix Simon XT User Manual

Device
Glassbreak sensor*
Motion sensor
Shock sensor*
Smoke sensor
Wireless panic button*
Key fob*
Remote handheld touchpad
* Not investigated for use by UL

Testing communication

Test communication between your system and the central monitoring station or a
voice report destination at least once per week to make sure you have the proper
telephone connection.
Note: The system must be in disarm mode.
To perform a communication test:
1. Scroll to
System Tests
2. Press Enter. The display shows
3. Enter the master code.
4. Press Enter to accept the master code. The display shows
5. Scroll to
Comm Test
6. Press Enter. The display shows
7. After the communication test is successful, the display shows
8. Press STATUS repeatedly to exit.
Note: If your system is not connected to a central monitoring station and you
do not have a voice report destination programmed, you won't be able to
perform the communication test.
If the communication test is successful, the system displays Comm Test Ok. If
the test is unsuccessful, the STATUS button will light and within ten minutes the
panel will display Comm Failure. If a communication test fails, call your security
system dealer.
36
To trip device
Trip with appropriate glassbreak tester.
Avoid the motion sensor's view for 5 minutes, and then enter its
view.
Tap the glass twice, away from the sensor. Wait at least 30
seconds before testing again.
Press and hold the test button until the system sounds
transmission beeps.
Press and hold the appropriate button for 3 seconds.
Press and hold Lock and Unlock simultaneously for 3 seconds.
Press and hold the two Emergency buttons simultaneously for 3
seconds.
.
Enter Code
.
Comm Test is On
.
Comm Test
.
Comm Test Ok
Simon XT User Manual
.
.