Programming Pendants And Sensors; Removal Of Pendants And Sensors - Tunstall smart hub User Manual

Programming pendants and sensors

While your Smart Hub comes with a pre-programmed pendant, if you have
purchased an additional pendant or a telecare sensor follow the step-by-
step instructions to program them in:
Step 1
Step 2
Step 3
Step 4
Step 5
Alternatively you can contact the response centre by pressing the help
button and they can remotely program the pendant or telecare sensor in for
you.

Removal of pendants and sensors

If you have lost or no longer use the pendant or sensor, the Smart Hub will
alert that the sensor is missing. To stop these alerts the sensor needs to be
de-programmed from your Smart Hub. Please contact the response centre
who will be able to de-programme the pendant or sensor for you.
Press and hold down the green cancel button until it beeps
(approximately 5 seconds). Release the cancel button, the
Smart Hub announces "Programming Mode" and the red
alarm button flashes slowly.
Press and hold down the green cancel button again until it
beeps (approximately 3 seconds). Release the cancel
button, the Smart Hub announces "Registration Mode" and
the red alarm button flashes rapidly.
Activate the pendant or telecare sensor, the Smart Hub will
beep to confirm acceptance.
Press and release the green cancel button. The Smart Hub
will beep (programming mode exited).
Test the pendant or telecare sensor by activating it and
ensuring it raises an alarm call.
Page 8 of 12