PRESONUS studiolive III series Owner's Manual page 39

5 The Fat Channel
5.1 Fat Channel Navigation
pass through unaffected. You can set the threshold from 0 to -84 dB. See Section
5.1.2 for more information on the Noise Gate and its parameters.
5. Compressor Threshold. This encoder sets, and the scribble strip displays, the
compressor threshold for the selected channel or output bus. When the signal's
amplitude (level) exceeds the threshold setting, the compressor engages.
Turning the knob counterclockwise lowers the threshold so that compression
begins at a lower amplitude. The threshold can be set from -56 to 0 dB. See
Section 5.1.3 for more information on the Compressor and its parameters.
6. Limiter Threshold. This encoder sets, and the scribble strip displays, the
threshold of the limiter for the selected channel or output bus. When the signal's
amplitude (level) exceeds the threshold setting, the limiter is engaged. Turning
the knob counterclockwise lowers the threshold, so limiting begins at a lower
amplitude. The Limiter ratio is ∞:1.
7. Digital Send Pre/Post. Use the encoder or button to toggle any digital sends
from the current channel between pre-and-post-fader operation. Pre-fader
mode means that send level is unaffected by channel fader level. Post-fader
means that send level is scaled by channel fader level.
8. Delay. Sets the alignment delay for the currently selected input or bus.
More information about input and output delays and be found in Section 11.6
and 11.7.
While an Input channel is selected and Input mode is active, the Channel Overview is
displayed in the Touch Screen:
1 2 3
17
16
15
14
13 12 11
1. Signal Source. Displays whether this channel is receiving signal from an analog
or digital source.
2. Link. Links or unlinks the channel to the adjacent channel or bus to create a
stereo pair.
3. EQ. Displays the EQ overview. Touch to open the EQ Screen. See Section 5.1.4 for
more information.
4. Name and Number. Displays currently selected channel or bus name and
number.
5. Settings Button. Touch to access additional channel or bus settings.
6. Current Parameter. Displays currently controlled parameter and its value.
7. Aux and FX Send Levels. Displays the send levels for current channel. Touch this
area to open Channel Bus Sends screen. See Section 5.1.5 for more information.
8. Main and Subgroup Assignments. Use these controls to assign/unassign the
current channel to the Main bus and Subgroups.
9. Limiter. Displays the Limiter overview. Touch to open the Limiter Screen.
10. Compressor. Displays the Compressor overview. Touch to open the Compressor
Screen. See Section 5.1.3 for more information.
11. Gate. Displays the Noise Gate overview. Touch to open the Noise Gate Screen.
See Section 5.1.2 for more information.
4 5 6
10 9 8
StudioLive™ Series III
Owner's Manual
7
35