Ametek 420VA Manual page 26

North American Models ABCE422-11 and ABCE422-11MED
Front Panel Controls
• Power On/Off
• Test
• Load Level LED Gauge
• Battery Charge LED Gauge
• Voltage Manager Boost LED
• Voltage Output On LED
• Voltage Manager Buck LED
• On Battery LED
• Replace Battery LED
• Overload LED
• Fault Code LED
• System Over Temperature LED
Rear Panel Information and Controls
• Six (6) Foot Power Cord with NEMA 5-15P Plug
• Four (4) NEMA 5-15R Receptacles
• Configuration Manager DIP Switches
• Communications Manager DB9 Port, USB Port
• Circuit Breaker
• AC Inlet Module
Internal Batteries
• User Hot-Swappable (See Instruction Manual)
• Type: 12 Volt, High Rate 21W
• Quantity: 2 Batteries
• Recharge Time: 6 Hours to 80%, 24 Hours to Full Charge
Environmental
• Temperature: 0 to 40℃ (32 to 104℉) Operating
-20 to 60℃ (-40 to 140℉) Shipment/Storage
• Humidity: 5 to 90% Non-Condensing (Operating,
Shipment/Storage)
• Altitude: 3,000m (10,000 ft) max. Operating;
12,000m (40,000 ft) max. Shipment/Storage
NOISE REJECTION-ISOLATION: With unit under power and an ANSI/IEEE C62.41Cat. A pulse applied either normal or
common mode at the input, the noise output voltage will be less than 10V normal mode and less than 0.5V common mode
in all four quadrants (CM-NM, NM-NM, CM-CM, NM-COM).
SURGE VOLTAGE WITHSTAND CAPABILITY: Tested under power to ANSI/IEEE C62.41 Cat. A & B (formerly
IEEEE587-1980). CAT. A - 6000V @ 200 amps, 0.5 usec risetime, 100 kHZ decay, Cat. B - 6000V @ 500 amps, 0.5 usec
risetime, 100 kHZ decay.
Warranty/Support: POWERVAR warrants the electronics and transformers used in its uninterruptible power managers
to be free from defects in materials and workmanship for a period of five years from the date of shipment. Batteries are
warranted for a period of two years from the date of shipment. For service or support on any POWERVAR product, please
contact POWERVAR Technical Support at (800) 369-7179 or visit the POWERVAR website at www.powervar.com.
Battery Life Disclaimer: POWERVAR's standard battery warranty applies only to UPS and UPM products which are
continuously connected to AC mains power, except during utility power outages. Products which are regularly and inten-
tionally disconnected from AC mains power will experience battery discharge/charge cycles potentially far more numerous
than those for which the battery was designed. As a result, products used in such applications will experience substantial-
ly reduced battery life. For that reason, POWERVAR's standard battery warranty does not apply for applications in which
the UPS or UPM product is regularly and intentionally disconnected from AC mains power. POWERVAR UPS and UPM
products used in such applications shall receive a 90 day warranty on batteries.
26
Safety Agency and EMC Compliance:
All Units are Listed by UL and Marked With the UL/cUL Marking
Standard UPM:
Products Listed to:
• UL1778 5th Edition
• CSA 22.2 Nos. 107.3-14
Products in Compliance with:
• FCC-Part 15, Subpart B, Sections 15.107b & 15.109b
Class A Digital Device*
• CISPR11:2009, A1; 2010, Class A*
• IEC61000-4-2, Electrostatic Discharge
• IEC61000-4-3, Radiated Electromagnetic Field Immunity
• IEC61000-4-4, Electrical Fast Transient/Burst Immunity
• IEC61000-4-5, Surge Immunity
• IEC61000-4-6, Immunity to Conducted Radio Frequency
Disturbances
• IEC61000-4-8, Power Frequency Magnetic Field Immunity
• IEC61000-4-11, Voltage Dips, Short Interruptions and
Voltage Variations
Medical UPM:
Products Listed to:
• UL60601-1 2nd and 3rd Edition
• UL1778 5th Edition
• CSA 22.2 No. 601.1-M89
• CSA 22.2 No. 107-1-M91
• CSA 22.2 Nos. 0-M1982
• CSA 22.2 Nos. 0.4-M1982
Products in Compliance with:
• FCC-Part 15, Subpart B, Sections 15.107b & 15.109b
Class A Digital Device*
• CISPR11:2009, A1; 2010, Class A*
• EN60601-1-2 : 2007
*Note: Class B is Available as an Option
Please Consult Your Powervar Sales Representative
RoHS Compliance:
All Products (Standard and Medical) are RoHS Compliant
A01-00055 Rev G