Ametek 420VA Manual page 12

Unpacking the UPM
• Unpacking the unit in a low-temperature environment may cause
condensation to occur in and on the unit. Do not install the unit
until the inside and outside of the unit are absolutely dry {hazard of
electric shock}.
• The unit is heavy. Use caution when unpacking and moving the
unit.
Use care when moving and opening the carton. Leave the components
packaged until ready to install.
To unpack the unit and accessories:
1. Open the outer carton and remove the accessories packaged
with the unit.
2. Carefully lift the unit out of the outer carton.
3. Store the carton for future use.
Place the unit in a protected area that has adequate airflow and is free of
humidity, flammable gas and corrosion.
NOTE:
Before installation, please read and understand the following
instructions. Carefully examine the carton for damage. Notify
the carrier immediately if damage is observed. Be sure to save
the carton should you ever need to ship the UPM for repair or
maintenance.
12
CAUTION
This UPM is intended for indoor use only. Although your
UPM is very rugged, its internal components are not
sealed from the environment. The UPM must be installed
in a protected environment away from heat producing
appliances such as furnaces, radiators, and heaters.
Protect the UPM from exposure to dripping or standing
water and high humidity or condensing air conditions.
A01-00055 Rev G