Digital Projection INSIGHT 4K Dual LED & Quad Series
EDID on the DisplayPort and HDMI inputs
If you are using a computer graphics card or another source that obeys the EDID protocol, the source will automatically configure itself to suit
the projector.
Otherwise please refer to the documentation supplied with the source to manually set the resolution to the native resolution of the projector or
the nearest suitable setting. Switch off the source, connect to the projector, then switch the source back on again.
Using HDMI/DisplayPort switchers with the projector
When using an HDMI/DisplayPort source switcher with the projector, it is important to set the switcher so that it passes the projector EDID
through to the source devices. If this is not done, the projector may not be able to lock to the source or display the source correctly as its
video output timings may not be compatible with those of the projector. Sometimes this is called transparent, pass-through or clone mode.
See your switcher's manual for information on how to set this mode.
Additionally, sources which use HDCP encryption may not display properly when connected to the projector via a switcher. Refer to the
switcher's manual for more information.
Sources
1
Switcher
2
Projector
3
Connection Guide
1
2
EDID
EDID
EDID
The EDIDs in the switcher should be the same as the one in the projector.
SIGNAL INPUTS
3
EDID
Notes
The HDMI and DisplayPort inputs
are HDMI 1.4 compliant. Some
content may not display unless the
source is also compliant.
Rev B June 2016
page 34