Front Filter - INSIGHT 4K Dual LED Series Installation And Quick Start Manual

Digital Projection INSIGHT 4K Dual LED & Quad Series

Front filter

1. Remove the lens, if fitted. Loosen the six captive
screws on the front cover of the projector, then
remove the cover.
2. Remove the air filter.
3. If you are replacing the filter, skip this step.
To clean the filter, use a vacuum cleaner brush
attachment to vacuum away dust from the air filter.
Avoid making direct contact without an attachment
or using a nozzle attachment.
Installation and Quick-Start Guide
CLEANING AND REPLACING THE FILTERS, DUAL LED
Notes
The information
on this page refers to
INSIGHT 4K Dual LED.
Before changing the filters,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the filters, avoid
using excessive force as this may
damage the equipment.
Filters should be replaced as
necessary upon visual inspection
and in accordance with operating
environment.
Rev B June 2016
page 19