Table of Contents
Advertisement
Digital Projection INSIGHT 4K Dual LED & Quad Series
Fitting The Lens
1.
Insert the lens into the mount.
Engage the three locating studs
slots
on the mount.
2
2.
Rotate the lens clockwise until the studs slide all the way into
the slots.
3.
Tighten the two fixing screws
3
Installation and Quick-Start Guide
into the corresponding
1
on the lens collar.
FITTING THE LENS
1
2
3
Notes
Before changing the lens,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the lens, avoid
using excessive force as this may
damage the equipment.
Take care to preserve the original
lens packaging and protective caps
for future use.
The projector will not power on
without the lens fitted.
Before turning on the projector,
please ensure the protective caps
are removed from the front and rear
of the lens.
The two fixing screws must be
tightened to at least a torque
of 0.5 N-m using a screwdriver.
Loose screws might lead to the
lens falling off.
When a new lens is fitted, a
calibration procedure must be
carried out. For more information,
see
Calibrating zoom and focus
further in this guide.
Rev B June 2016
page 16
Advertisement
Table of Contents
