Table of Contents
Advertisement
Digital Projection INSIGHT 4K Dual LED & Quad Series
Calibrating zoom and focus
Each time a new lens is fitted into the projector, a calibration procedure must be carried out as follows:
Calibrate zoom and focus using the keypad:
•
Press
followed by the
RPY
RIGHT
•
Press
followed by the
RPY
LEFT
Calibrate zoom and focus using the remote control:
•
Press and hold
CAL
, then press
When calibrating, select one command first, then allow at least 60 seconds for the calibration to take place before selecting the other
command.
Adjusting the lens
On either the remote control or keypad:
•
Focus
Press to enter FOCUS ADJUSTMENT mode, then use the arrow keys to make the adjustment.
•
Zoom
Press to enter ZOOM ADJUSTMENT mode, then use the arrow keys to make the adjustment.
•
Shift
Press to enter SHIFT ADJUSTMENT mode, then use the arrow keys to make the adjustment.
Adjusting brightness, contrast and other settings
You can access a variety of settings to adjust using the Projector Controller software, which is available for download from the Digital
Projection website, free of charge.
Please refer to the Projector Controller user manual for details about installing and using the software.
Installation and Quick-Start Guide
arrow key to calibrate the lens zoom mechanism.
arrow key to calibrate the lens focus mechanism.
ZOOM
or
FOCUS
to calibrate zoom or focus respectively.
OPERATING THE PROJECTOR
Notes
When adjusting focus or zoom, UP
and LEFT will focus/zoom in, while
DOWN and RIGHT will zoom out.
When adjusting shift, each arrow
key moves the image in the
corresponding direction on the
screen.
When you enter FOCUS, ZOOM
or SHIFT ADJUSTMENT mode,
all other remote control functions
become unavailable. To cancel an
adjustment mode, either press
EXIT
or wait ten seconds.
Rev B June 2016
page 28
Advertisement
Table of Contents
