Adjustment; (A) Fine Adjustment - MBM AeroFold 1500S Operation Manual

(8) Adjustment

(A) Fine Adjustment

Adjusting Table 1 or Table 2
Select the Stopper Move Mode key (Table 1or 2). The
lamp of the selected Stopper Move Mode key illuminates.
The present stopper position is shown on the [Counter].
In case of standard-size paper, the stopper moves automatically to
the suitable position according to the paper size and fold type.
Apply this adjustment when fine adjustment is in need for
the folding position.
Values input manually return to standard values if any one
of other fold type keys is pressed.
Press the +/- key and move the stopper to the desired position.
The value displayed to the [Counter] shows the position of the
stopper. (Unit: inch)
Example: When display of the [Counter] is 11.38, the stopper
position is 11.38 inch.
The position can be moved based on a unit of 0.003 inch.
Note indicator shows lowest of 2nd digits from decimal point.
Press the Stopper Move Mode key (Table 1 or 2) again.
The lamp on the selected Stopper Move Mode key flashes.
Regarding the adjustment, refer to the table of page 31.
The length of the arrow for each fold type is set based on the
stopper position of Table 1 or 2.
Example, In case of Double Parallel,
Table 1: Fold a half of the overall length
Table 2: Fold one fourth of the overall length
Note: To prevent damage to the Interceptor Push Bar at Stopper of Table 1, it does not come into contact with
Interceptor when stopper is moved by manual mode to avoid enforced pushing.
With automatic mode only, it comes to contact with Interceptor to make by-pass the Table 1.
Depending on environmental humidity, paper stretches or shrinks. Adjust Table 1 or 2 as it is needed.
By changing speed, folding position may move. Adjust Table 1 or 2 as it is needed.
Table1
stopper move
mode key
29
www.WhitakerBrothers.com
Table2
stopper move
mode key
Counter
+/- key