(4) Designation and Functions of Operations Panel
⑬
⑲
⑱
⑰
⑯
Designation/Indication
No.
①
START/STOP key
②
TEST key
③
Speed adjustment key
④
Paper feed table up/down key
⑤
Store key
⑥
Memory 1/2/3 key
⑦
Fold type key
⑧
Counter
⑨
Clear/Reset key
⑩
+/- key
⑪
Numerical key
⑫
Table 2 stopper move mode key
⑬
Table 1 stopper move mode key
⑭
Paper length input mode key
⑮
Interval key
⑯
Paper ejection roller move key
⑰
Check lamp
⑱
Cleaning lamp
⑲
Perforation mode lamp
⑪
⑧
⑫
⑨
⑩
⑭
⑮
Starts and stops machine.
1) Test folds two sheets without counting.
2) Also test blow without folding, when pressed more than 2 seconds.
Adjusts speed.
Moves up and down the paper feed shelf.
Fold position after adjustment is stored.
Three special fold types are stored.
Six fold types can be input and stored.
Shows the number of sheets, the position of the
stopper pin of Table 1 and 2, and paper size.
Clears the counter / resets after an error.
Used for adjusting the position of the stopper of Table 1 and 2, the
position of paper ejection roller, and paper length
Used for inputting the number of sheets to be folded and the length of
non-standard size paper
Indicates when the position of stopper of Table 2 is adjusted.
Indicates when the position of stopper of Table 1 is adjusted.
Indicates when paper length is input
Sets a certain time of interval to stop paper feed.
Indicates when the position of the paper ejection roller is adjusted.
Indicates when paper stock runs short, or the location of paper feed
trouble.
Indicates when cleaning of the FEED section (belt, roller) is necessary.
It lights every after 10,000 peaces of paper are fed.
For reset, turn on the machine holding down – key.
You can disable this function when you turn up the machine keep
pushing [single (Fold type)] key.
You can activate this function again when you turn up the machine
with[gate(Fold type)] key pushed.
Indicates when the optional perforating unit is installed.
11
⑦
⑥
⑤
Function
www.WhitakerBrothers.com
②
③
①
④