(C) Setting Of Table 2 - MBM AeroFold 1500S Operation Manual

(C) Setting of Table 2

Make sure that no paper is loaded on the paper feed table, and
press the paper feed table Up and Down Key so as to raise the table
until it stops at the uppermost point.
For installing or removing table 2, do it after raising the paper
feed table up to the highest point using the paper feed table Up and
Down Key.
In case the paper feed table is located at any place other than
the lowermost point, if the paper feed table Up and Down Key is
pressed, it moves down to the lowermost point. Therefore, press the
paper feed table Up and Down Key again to raise it to the
uppermost point.
In case the paper feed table is located at the lowest point, if
the paper feed table Up and Down Key is pressed, the table moves
up.
If the paper feed table Up and Down Key is pressed while the
paper feed table is in operation, the paper feed table stops motion.
Open the door for the table 2.
Place the Guide Bracket of Table 2 on the Table Guide 2 on both
sides.
14
www.WhitakerBrothers.com
Table up and down key
Ta bl e2 G u i de
Guide Bracket