●In auto-preset mode, the set value can be automatically calculated and stored.
Auto-preset is a function to automatically calculate the approximate set values according to the actual
operating condition.
If the
button is pressed during measurement mode after auto-preset function is selected, the display
will appear as shown in the table below.
•Display during auto-preset
Output mode
Hysteresis mode
Display during
auto-preset
The Display flashes when the
flashing.
The set value is automatically calculated by pressing the
completed and the display will return to measurement mode.
The set values of auto-preset mode are calculated as follows
Auto-preset set value
Hysteresis mode
•P_1 = A - (A - B)/4
•H_1 = (A - B)/2
Set
value
(n_1 = B +
in reversed output mode)
Refer to the list of output operations (page 26) for the setting of hysteresis mode and window comparator
mode.
Normal output
Window comparator
button is pressed. The flow should be changed while the display is
•P1L = B
•P1H = A
•H_1 = 5 digit
A - B
4
1 digit means the minimum set unit
(In reversed output, P1L, P1H becomes n1L, n1H respectively)
Hysteresis mode
mode
button. Then, auto-preset mode setting is
Window comparator mode
-37-
Reversed output
Window comparator
mode
No.PF※※-OMJ0006-G