Honeywell 5704 Operating Instructions Manual page 130

MAN0448_Issue 13_ 01-2010
005704-M-5001 A03249
CHAPTER 5 - COMMISSIONING AND
MAINTENANCE INSTRUCTIONS
Error
Code
96
95
94
93
92
91
Error Code Meaning
No Vps.
Vps is a voltage which is used to set the
absolute value reference for the reading scaling
factor.
The no Vps message is only displayed on
a channel card that has not been factory
tested.
This is a serious card failure and, as such, the
card needs to be replaced.
Not used.
Not used.
Configuration Fault
The configuration fault message is displayed
during start-up if the channel card has no
configuration information or the configuration
is not valid..
This is a serious card failure and, as such, the
card needs to be replaced.
Not used.
Power Fail Error
The power fail error message is displayed if the
system supply voltage falls below approximately
16V dc.
The error latches* if the power failure delay is
not enabled.
Check the operation of the power supply. When
the power is restored, check the operation of the
system.
5-9
5704 Control System
Software Card Fault latch
Version Status Signal
All Non Yes
Active
All Non Yes
Active
1V5 Non Yes
Active
1V6 Non Yes
or Active
later
Yes
Yes
No
Conf*