Honeywell 5704 Operating Instructions Manual page 26

MAN0448_Issue 13_01-2010
005704-M-5001 A03249
CHAPTER 2 - SySTEM DESCRIPTION
5.2.2 Quad Relay Card Rear Access Connections
Rl1-NC (Master Fault)
Rl1-COM (Master Fault) 3
Rl2-NC (Master A1)
Rl3-NC (Master A2)
Rl3-COM (Master A2)
Rl4-NC (Master A3)
Ground
Channel 1 (S)
Channel 1 (01)
Channel 1 (NS)
Channel 3 (S)
Channel 3 (01)
Channel 3 (NS)
Analogue 24V
Analogue CH1
Analogue CH3
Remote Reset
+24V Input
1. NC = Normally Closed. NO = Normally Open. COM = Common.
2. Relay contact conditions refer to the no power state of the relay.
3. The functions shown for terminals 1 to 12 are the default functions for
relays RL1 to RL4 only. For other configurations - refer to the configuration
printout.
1
5
7
9
11
13
15
17
19
21
23
25
27
29
31
33
35
2-12
5704 Control System
2 Rl1-NO (Master Fault)
Slot location label
4 Rl2-COM (Master A1)
6 Rl2-NO (Master A1)
8 Rl3-NO (Master A2)
10 Rl4-COM (Master A3)
12 Rl4-NO (Master A3)
14 Ground
16 Channel 2 (S)
18 Channel 2 (01)
20 Channel 2 (NS)
22 Channel 4 (S)
24 Channel 4 (01)
26 Channel 4 (NS)
28 Analogue 0V
30 Analogue CH2
32 Analogue CH4
34 Remote Inhibit
36 0V Input
label for
User Terminal
Reference