16-Way Ac To Dc Power Supply Unit Upgrade To 150W Or 200W - Honeywell 5704 Operating Instructions Manual

MAN0448_Issue 13_01-2010
005704-M-5001 A03249
CHAPTER 4 - INSTAllATION INSTRUCTIONS
(5) Insert the module, with the same orientation as the already fitted
module, into the vacant position inside the 50W Sub Unit and secure
using the washers and long nuts retained in Step (3).
(6) Connect the 50W Sub Unit second ac input and 24V dc output cable
connectors to the ac input terminal CN1 and dc output terminal CN2
respectively on the added 50W Switched Mode Module as shown
below:
CN2
DC Output
(7) Refit the top cover.
17.3 16-Way AC to DC Power Supply Unit Upgrade to 150W or
200W
To upgrade the 16-Way AC to DC Power Supply Unit to 150W or 200W
proceed as follows:
(1) Fit a second 50W Sub unit, containing a 50W Switched Mode
Module, to the 16-way AC to DC Power Supply Unit front panel
using the fixings supplied.
(2) When an upgrade to 200W is required, fit a further 50W Switched
Mode Module into the new 50W Sub unit as indicated in Section
17.2.
4-57
5704 Control System
CN1
AC Input