Installing The Cisco Mds 9396S Switch - Cisco MDS 9396S Hardware Installation Manual

Installing the Cisco MDS 9396S Switch

This chapter describes how to install the Cisco MDS 9396S switch and its components.
Before you install, operate, or service the system, see the
Note
for the Cisco MDS 9000 Family
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before
you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents. Use the statement number provided at
the end of each warning to locate its translation in the translated safety warnings that accompanied
this device. Statement 1071
SAVE THESE INSTRUCTIONS
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security. Statement
1017
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Each new switch requires a license; see the
Note
instructions on installing a license.
• Preinstallation, page 16
• Installing the Switch, page 19
C H A P T E R
Regulatory Compliance and Safety Information
for important safety information.
Cisco MDS 9000 Family NX-OS Licensing Guide
Cisco MDS 9396S Multilayer Fabric Switch Hardware Installation Guide
3
for
15