Supported Power Cords And Plugs; Power Cords - Cisco MDS 9396S Hardware Installation Manual

Supported Power Cords and Plugs

The following figure shows a schematic of the 10/100BASE-T cable.
Figure 19: Twisted-Pair 10/100BASE-T Cable Schematic
Supported Power Cords and Plugs
A separate power cord is provided for each power supply. Standard power cords or jumper power cords are
available for connection to a power distribution unit having IEC 60320 C13 outlet receptacles. The jumper
power cords, for use in cabinets, are available as an option instead of the standard power cords.

Power Cords

The standard power cords have an IEC C15 connector on the end that plugs into the switch. The optional
jumper power cords have an IEC C15 connector on the end that plugs into the switch, and an IEC C14 connector
on the end that plugs into an IEC C13 outlet receptacle.
Only the standard power cords or jumper power cords provided with the switch are supported.
Note
Cisco MDS 9396S Multilayer Fabric Switch Hardware Installation Guide
66
Cable and Port Specifications