Installing And Removing The Fan Tray; Installing The Fan Tray - Cisco ASR-920-12SZ-IM Hardware Installation Manual

Installing and Removing the Fan Tray

Step 2
Slide the open end of your 2-hole ground lug over the exposed area of the ground wire.
Step 3 Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the ground wire as shown
in the following figure.
Figure 21: Crimping a Ground Lug on to the Ground Wire
Step 4 Use a Phillips head screwdriver to attach the 2-hole ground lug and wire assembly to the router with the 2 pan-head
Phillips head screws.
Step 5 Connect the other end of the ground wire to a suitable grounding point at your site.

Installing and Removing the Fan Tray

This section describes how to install and remove fan trays.

Installing the Fan Tray

Follow these steps to install the fan tray in the chassis:
Caution Electric Shock Hazard: This fan tray has to be serviced by trained personnel only.
Always wear the ESD wrist strap when installing or uninstalling the fan tray.
Caution
Unplug all power sources before performing this procedure.
Caution
Cisco ASR-920-12SZ-IM Aggregation Services Router Hardware Installation Guide
60
Installing the Cisco ASR 920 Series Router