Usb; Factory Reset; Utilities; System Utilities - Martin Audio BlacklineX SERIES User Manual

BlacklineX
Limit, 0 dB, –3 dB, –6 dB, –9 dB, –12 dB and –15 dB.
17. USB
The DX0.5 may be controlled and programmed using a Windows‐based PC. Go to www.Martin Audio.com/Software to download
the free application and driver. Here you will also find presets for other Martin Audio product ranges
Simply connect a USB cable from the DX0.5 to the PC in order to control all parameters of the processor via the DX0.5 Application.
Factory Reset
It is possible to reset the DX0.5 Loudspeaker Management System to its factory settings. Please keep in mind that this erases all
settings, including any passwords and presets that may have been set. Be sure to power down any amplifiers and/or powered
speakers before resetting the DX0.5.
Simply press and hold the Enter [10], ESC [11] and Utility [12] buttons when powering up until the LCD
Display [6] shows:
Then you may take your fingers off the buttons. You will know it worked when the six output Mute LEDs [15] illuminate after the
DX0.5 is fully powered up.
The default password is six zeroes: 000000

Utilities

As mentioned earlier, there are three main utility menus to choose from:

System Utilities

Preset Utilities

Security Utilities
Within each utility menu, an array of sub‐menus are available. We will go through each utility, each submenu, how to get there,
how to edit and change settings and what each Control and button does in each situation.
When navigating menus, the current setting for any parameter will be indicated with an asterisk [*] making it easy to get back
where you started.
Press the Utility Button [12] to open the Utility Menu.
Use the Nav/Edit1 Control [7] to navigate between the three utility menus: System Utilities, Preset Utilities and Security Utilities.
Press the ESC button [11] to return to the main screen.
Press the Enter Button [10] to enter and edit the selected Utilities menu. This is how we reach the sub‐menus of the Utilities.
System Utilities
Turn the Nav/Edit1 Control until System Utilities is presented and press the Enter Button [10] to reach the System Utilities sub‐
menus as listed below:

System Setup

Delay Units

Ramps on changes

Software Version
Looking at each of these sub‐menus individually;‐
1. The Nav/Edit1 Control [7] is used to navigate between the four System Utilities.
2. The ESC button [11] is used to return to the System Utilities menu.
BlacklineX User Guide V1.0
USER GUIDE
Please Wait....
Memory Reset
32