Main: Lift / Gnd; Xlr Outputs; Xlr Inputs; Front Panel - Martin Audio BlacklineX SERIES User Manual

BlacklineX
The fuse is located behind the fuse cover, at the bottom of the IEC socket. See the "Troubleshooting" section on page 22 for
information about replacing the fuse.
3. Main: Lift / Gnd
The ground lift separates the chassis ground from the signal ground. The default position is GND. You may attempt to remedy
system ground loop hum by moving the switch to LIFT.
4. XLR Outputs
These six male XLR connectors provide a balanced line‐level signal for each of the processor's output channels. Connect these to
the inputs of power amplifiers and/or powered loudspeakers.
5. XLR Inputs
These female XLR connectors accept a balanced line‐level input from a mixer or other source main L/R output.
Front Panel
6. LCD Display
The LCD Display is one of the most vital features of the processor. It displays processor information including (but not limited to)
System, Preset and Security Utilities, gain, delay, EQ and other input and output processing parameters.
When the DX0.5 is powered up, the last state it was in will load up and the LCD Display will present the current system setup
type:

2xStereo+Sub [default]

2x2Way+Sub

2x3Way

3xStereo

1x6Way
7. Nav/Edit1 Control
The Nav/Edit1 rotary encoder control allows you to navigate the user interface, edit sections of the processor, navigate within
screens to select sub‐menus, pages and parameters, as well as select values during editing.
8. Edit2 Control
The Edit2 rotary encoder control allows you to edit parameters, as well as select values during editing.
9. Edit3 Control
The Edit3 rotary encoder control also allows you to edit parameters, as well as select values during editing.
In general, use the Nav/Edit1 rotary encoder control to scroll through the various pages and configuration settings. Depending
on the page, individual parameters may be changed by turning one (or more) of the encoders. In some cases, the Edit2 and Edit3
controls provide fine and course control of the same parameter.
BlacklineX User Guide V1.0
USER GUIDE
WARNING: Bypassing the plug's safety ground pin can be dangerous. Don't do it!
30