Keyclick; Display; Status And Error Messages; Remote Programming - Display - Keithley 2701 User Manual

Model 2701 User's Manual

Keyclick

With keyclick enabled, an audible click will sound when a front panel key is pressed. Per-
form the following steps to disable or enable keyclick:
1.
2.
Remote programming
The following command controls keyclick:
SYSTem:KCLick <b>
where: <b> = ON or OFF
NOTE

Display

Readings are displayed in engineering units (i.e., 100.23mV), while annunciators indicate
various states of operation. See "Front panel summary," page 1-10, for a complete listing
of display annunciators.
NOTE

Status and error messages

Status and error messages are displayed momentarily. During operation and programming,
you will encounter a number of front panel messages. Typical messages are either of status
or error variety, as listed in Appendix C.
Remote programming — display
Using remote programming, the Model 2701 can display a custom ASCII message (up to
12 characters). Also, the front panel display and controls can be disabled.
Display commands
The commands are listed in Table 1-3. Details on these commands follow the table.
Press SHIFT and then LOCAL to display the present state of KEYCLICK (ON or
OFF).
Press or to display the desired keyclick state and press ENTER.
Keyclick ON is the FACTORY, *RST, and SYSTem:PRESet default.
The display test allows you to test display digit segments and annunciators. The
key test checks the functionality of front panel keys. These tests are accessed by
pressing SHIFT and then TEST. Refer to the Model 2701 Service Manual for
details.
Getting Started
' Enable or disable keyclick.
1-19