Installation; Operation - Omcan MS-IT-0300-H Instruction Manual

use.
• The blade cover (6) must be in position over the knife and secured by tightening the hand knob (7).
• The Iast slice device (4) must be used when slicing it keep your hands away from the knife. When the slicer
is not running, the slicer thickness control (2) must be set to zero (fully clockwise) to prevent the blade edge
from being exposed.
• Always UNPLUG the power cord before cleaning or moving the slicer.
• Pull the product holder (3) towards you until it stops and place the product
to be sliced on the product holder tray.
• Set the last slice device against the product and switch on the slicer by
pressing the on-off switch (9).
• Adjust the slice thickness by turning the slice thickness control.
• The numbers on the slice thickness control do not indicate actual
measurements but may be used for reference to duplicate slice thickness.
• Using the last slice device (4), push the product holder (3) back and forth
to slice.
• Always switch-off the slicer and turn the slice thickness control clockwise
to zero when not slicing.
CLEANING
This machine must be thoroughly cleaned after each day's operation
or anytime it will not be used for an extended period of time.
WARNING: Unplug machine power cord and turn the index knob fully
clockwise before cleaning the slicer.
• Turn the slice deflector (12) for easy cleaning back of the blade.
• The product holder can be removed for an easy cleaning by
rotating its handle counterclockwise (8).
• Using a mild soap, hot water solution, and a clean cloth, wipe all
surfaces of the slicer.
• Thoroughiy rinse it with another clean cloth and fresh water.
• Remove the blade cover by removing the hand knob (7).
Maintenance
7
12
7

Installation

Operation

10
6
14
3
9
2
11
1
4
8