Philips BJ2.4U Service Manual page 28

EN 28 5. BJ2.4U/BJ2.5U PA
action holder: MIPS
action holder: St-by
autonomous action
Power-down HDMI and 1394 hardware by keeping
POWERDOWN-1394 GPIO 0 line high.
Set Viper HW blocks (TM1, TM2, MBS, VMSP1 and
Hibernate the PNX2015 memory and keep the
Disable +8V6 supply detection algorithm
Switch OFF all supplies which are not needed in POD
standby by switching HIGH the ON-MODE I/O line.
Service Modes, Error Codes, and Fault Finding
Semi Stand by
This state transition is entered when standby is requested
and an authenticated POD is present. When in semi-
standby, the CEservices will set the POD standby NVM
bit and ask infra to reboot. After the reboot, POD standby
will be entered. The Trimedia images are not started in
this case and CEsvc will ask infra to enter the Hardware
Reboot
VMSP2) to powerdown mode.
PNX2015 in reset state
Disable audio protection algorithm
POD standby
Figure 5-14 "Semi Stand-by" to "POD Stand-by" flowchart
POD standby state.
G_15960_134.eps
100306