12. Remove screws [10].
13. Use brackets [11] to lift the panel from the set and put it at
a safe place.
14. Remove screws [12] and the brackets from the panel, and
install the brackets on the new panel.
4.4
Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
While re-assembling, make sure that all cables are placed
and connected in their original position. See figure "Cable
dressing".
•
Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
Mechanical Instructions
BJ2.4U/BJ2.5U PA
4.
EN 13