Philips BJ2.4U Service Manual page 11

9. Remove screws [8].
10. Remove SSB from the set.
5 5
2
4
5
Figure 4-12 Rear SSB shield
6 6
6
Figure 4-13 Bottom SSB shield
For removing Rear I/O Panel (see figure "Rear I/O"):
1. Unplug connector [9].
2. Remove screws [10].
3. Remove the panel from the set.
Figure 4-14 Rear I/O panel
4.3.10 SDI PDP Power Supply Panel
See figure "SDI PDP Power supply panel" for details.
Mechanical Instructions
5 5
3
5
5
1
5
G_15930_078.eps
190606
6 6 6
6 6
G_15930_079.eps
190606
7
10
10
9
8
10
10
G_15930_080.eps
190606
2
2
5
2
Figure 4-15 SDI PDP Power supply panel
1. Unplug connectors [1].
2. Remove screws [2].
4.3.11 AmbiLight Diffusor Frame (Step & Top)
Before the AmbiLight lamp units can be removed, the
AmbiLight diffusor frame must be lifted. Before this, the
speaker frame must be removed, as described earlier in this
chapter. See figure "AmbiLight diffusor frame removal" for
details.
Figure 4-16 AmbiLight Diffusor frame removal
1. Remove the remaining tapping T10 screws [1].
2. From the right AmbiLight Inverter Panel, unplug two cables
[2] that lead to the SSB.
3. Remove the side I/O panel and Control Panel as previously
described without unplugging the cables. Unclamp the
cables in the set and place the units in the centre of the set.
4. Carefully lift the plastic frame from the set. See Figure
"AmbiLight diffusor frame lift".
BJ2.4U/BJ2.5U PA
1
2
1
4. EN 11
2
2
2
G_15930_081.eps
190606
2 2
G_15960_109.eps
080306