Download  Print this page

Advertisement

QQ
3 7 63 1515 0
SPECIAL MENU MODE
Procedure:
1. Press the [POWER] button to turn on the main power, then while pressing the [TONE MODE] button, press the [A.F.D.], [2CH/
A.DIRECT], [MUSIC], [MOVIE] button in order, the message "MENU SPECIALIZED!" appears.
2. Up or down jog switch, the message "<<< SPECIAL >>>" appears.
3. Right jog switch, the item is appears.
4. Each time up or down jog switch, the item is switched in order as follows. Some items can change the content. Display the cursor by
right jog switch, and changing the content by up or down jog switch, and fi x the content by left jog switch when you want to change the
content of the item.
5. To release from this mode, while pressing the [TONE MODE] button, press the [A.F.D.], [2CH/A. DIRECT], [MUSIC], [MOVIE] but-
ton in order again, the message "MENU SPECIALIZED OFF" appears.
Items
SYSTEM version display
MAIN Ucom version display
Video Ucom version display
FAROUDJA version display
FAROUDJA (2nd) version display
GUI CG-ROM version display
DSP Ucom version display
DSP serial fl ash version display
DSP parallel fl ash version display
IR learning Ucom version display
Network IC version display
DSP debug menu
Network debug menu
TE
L 13942296513
MAC address display
(Network debug menu)
Zone 4 display
FAROUDJA update
HDCP key read
Learning test
Model/destination change
Video factory menu
Video calibration
(Video factory menu)
www
DDR access check
Auto cal mic test
.
FL display fonts test
http://www.xiaoyu163.com
Display
SYSTEM VERSION X.XXX
MAIN ##### ∗∗∗ vX. XX
Video Ucom Ver X. XX
FAROUDJA Ver X. XX
FAROUDJA2ND Ver X. XX
GUI CGROM Ver X. XX
DSP Ucom Ver X. XX
DSP SFLASH Ver X. XX
DSP PFLASH Ver X. XX
IR LEARNING Ver X.XX
NETWORK PNX Ver X.XX
<DSP DEBUG MENU>
<NETWORK DEBUG MENU>
MAC∗∗:∗∗:∗∗:∗∗:∗∗:∗∗
ZONE 4 XXXXXXXX
FAROUDJA UPDATE [XXX]
HDCP KEY READ [XXX]
LEARNING TEST START?
MODEL [##### ∗∗∗∗ XX]
<VIDEO FACTORY MENU>
V.CALIBRATION START?
DDR CHECK [XX] sec
x
ao
u163
y
SPEAKER OUT [XXXXX]
i
FL FONT [0x ∗∗ = X]
http://www.xiaoyu163.com
2 9
8
X.XXX: System software version
#####: Model
∗∗∗: Destination
X.XX: Main controller software version
X.XX: Video system controller software version
X.XX: Video processor software version (main zone)
X.XX: Video processor software version (2nd zone)
X.XX: CG-ROM software version
X.XX: DSP controller version
X.XX: Serial fl ash software version
X.XX: DSP parallel fl ash version
X.XX: IR learning software version
X.XX: Network IC version
Not used for the servicing
Menu mode to enter MAC address display. If the jog switch on
the set is pressed, entering the menu, and operating two the
Q Q
3
6 7
1 3
1 5
following menu become possible
∗∗:∗∗:∗∗:∗∗:∗∗:∗∗: MAC address
Not used for the servicing
XXX: ON or OFF
Not used for the servicing
Not used for the servicing
Not used for the servicing
Menu mode to enter video calibration menu and DDR access
check menu If the jog switch is pressed, entering the menu,
and operating two the following menu become possible
Procedure:
1. "DVD" is selected by using [INPUT SELECTOR] dial.
2. Connect a color pattern generator to the COMPONENT
VIDEO ASSIGNABLE (INPUT ONLY) IN2 jack (J6007) on
the A-VIDEO board and DVD VIDEO IN jack (J6003) on the
A-VIDEO board.
3. Input 100% color bars signal from the color pattern generator.
4. Menu that measures individual difference of hardness by
automatic operation in pressing the jog switch, and corrects
reference value. In a measurement once, only one of NTSC/
PAL/HD can be measured, repeat NTSC/PAL/HD calibration
from procedure 4.
"Check XXXX V-IN" at display:
Video signal necessary for the measurement while measuring
it last time was not detected and it became an error
Confi rm the input of the video of the terminal connection etc.,
and measure the jog switch again pressing
XX: Time to do access check on DDR (for design evaluation)
co
(Video factory menu)
XXXXX: Selection of speaker output audio [SOURCE]: normal-
.
ly mode, [MIC]: mode that output audio from mic from speaker
∗∗: 20 to FE, X: character
STR-DA6400ES
9 4
2 8
Remark
0 5
8
2 9
9 4
2 8
m
9 9
9 9
25

Advertisement

Table of Contents

   Related Manuals for Sony STR-DA6400ES

Comments to this Manuals

Symbols: 0
Latest comments: