Adjusting The Rotation; Adjusting Portrait Format; Fitting A Swivel Arm Or Wall Bracket - Fujitsu Zero Client DZ19-2 Operating Manual

14 - English

Adjusting the rotation

► Grasp the Zero Client's monitor with both hands on the right and left edge of
the casing and turn it to the desired position.

Adjusting portrait format

The Zero Client's monitor can be rotated from horizontal format (landscape
mode) to vertical format (portrait mode).
► Grasp the Zero Client's monitor with both hands on the right and left edge of
the casing, tilt the monitor backwards, move it into the highest position and
turn it clockwise until it is in the portrait position.
To be able to display the screen contents in portrait mode, the Zero Client Controller
software must support this function or you will need to use additional software.
To reset the monitor to landscape mode, the monitor should be turned anti-clockwise.
The OSD display can be reset again in the OSD menu.

Fitting a swivel arm or wall bracket

Before you can use a swivel arm or a wall bracket, you must first remove the base of the Zero Client.
The display surface of the Zero Client is sensitive to pressure and scratches.
1
2
For instructions on how to mount the swivel arm or wall bracket, please see
the documentation for the swivel arm or wall bracket.
16
► Switch off the Zero Client and pull the
power plug out of the power socket.
► Remove all cables.
► Lay the Zero Client on its front on
a soft surface.
3
► Remove the screws (1-4) on the rear
of the Zero Client.
4

You can now mount a swivel arm or a wall
bracket in accordance with VESA FPMPMI
using a hole spacing of 100 mm.
Getting started
Fujitsu Technology Solutions