Het Wijzigen Van De Zitdiepte Bij De Puma - Quickie Puma 40 Instructions For Use Manual

12.7.2 Procedure for connecting the charger and charging
• Connect the battery charger round output plug to the
charging socket on the front of the joystick module,
• (Fig. 12.2-12.4).
• Connect the charger to the mains supply by means of the
mains plug and switch on.
• The GREEN light will flash to show power is on and the
charger is initialising.
• The ORANGE light comes on to show that the batteries are
charging.
• Flickering between ORANGE and GREEN shows that
charge is almost complete.
• Solid GREEN indicates charge is complete.
For more information about the charger operation,
consult the instructions provided with the charger.
NOTE: If the charger is not connected to the wheelchair, it
does not output charge voltage.
The charger may be used with other brands of Gel type
batteries, subject to written confirmation from the Technical
Department of Sunrise Medical.
Fig. 12.2
Fig. 12.3
40
Puma 40 Sedeo Ergo
DANGER!
• An extension cord should not be used unless absolutely
necessary. Use of an improper extension cord could result in
a risk of fire and electric shock.
• If any extension cord must be used, make sure the pins on
the plug of the extension cord are the same number, size
and shape as those of the plug on the charger; and that
the extension cord is properly wired and in good electrical
condition.
WARNING!
• Always switch off at the mains before disconnecting the
batteries.
• The charger is designed for indoor use. Do not use outdoors
or expose to rain, snow, spray or moisture.
CAUTION!
When buying replacement batteries or charger always consult
your Sunrise Medical service agent. Do not leave the charger
connected to the battery with the mains disconnected or
switch ed off. This could result in damage to your battery being
caused by deep discharge over a period of time.
To reduce the risk of damage to electric plug and cord, pull by
the plug rather than the cord when disconnecting the charger.
Fig. 12.4
Charging Socket
3
1
2
Pin 1 = Battery Positive
Pin 2 = Battery Negative
Pin 3 = Inhibit
Rev.1.0