Quickie Puma 40 Instructions For Use Manual page 30

7.5.4 Delete custom programmed memory positions
Refere to Fig.7.12 - 7.15
1. Remove the rear cover of the backrest and connect a
Switch with a 3,5mm Jack to the socket on the CxSM,
(Complex Seating Module), (A-Fig. 7.4).
2. Press the "Mode" button one or more times until a seat icon
appears in the LCD control panel display, (Fig.7.5).
3. Move the joystick to the left or right to select a memory seat
position (Seating, Lie-Down, Relax or Custom Position),
(Fig.7.6). A seat icon and the memory description for
the relevant position are shown in the LCD control panel
display.
4. Press and hold the Switch connected to the CxSM, (Fig.7.7)
and pull the joystick backwards for 6 seconds. After 3
seconds you will hear the programming beep and after 6
seconds you will hear a change in the beep sound.
5. As soon as you hear this new sound release the Joystick
and the button. All memory positions are now set to the
factory settings.
7.5.5 Return to drive mode
Press the "Mode" button one or more times until a standard
display image with speed indicator appears in the LCD control
panel display.
30
Puma 40 Sedeo Ergo
Fig.7.4
Fig.7.5
Relax
Fig.7.6
Fig.7.7
A
Rev.1.0