Everyday Use; Base Dosage - Bosch WAYH32I9SN Instruction Manual And Installation Instructions

When the appliance is switched on, the
following indicates that the detergent
drawer is closed completely:
The corresponding illuminated
■
display on the drawer handle lights
up when intelligent dosing i-DOS is
selected
The display flashes once and then
■
goes out if intelligent dosing is not
selected.

Everyday use

Illuminated displays on the drawer
handle:
The display lights up if intelligent
■
dosing is selected for the
corresponding dispenser:
– w for dispenser ß (detergent),
– for the iIw illuminated display for
the combined compartment i/ß,
the lamp for the appropriate
dispenser content lights up:
i for fabric softener/w for
detergent. ~ Page 48
The display flashes if the fill level of
■
the selected intelligent dosing
dispenser is below the minimum
level.
(De)selecting intelligent dosage and
adjusting the dosage strength:
The intelligent dosages for detergent
and fabric softener are set at the factory
for programmes in which intelligent
dosing can be used.
Overview of programmes ~ Page 32
The dosage strength has been preset to
low (lightly soiled laundry) for
detergent w and to medium (medium
Intelligent dosing system
level of softness) for fabric softener i. It
can be changed for each programme.
~ Page 39
In addition to intelligent dosing, cleaning
aids (e.g. stain remover) can be added
manually to compartment v u, if
necessary. ~ Page 51
Depending on the programme,
Note:
the selection (on/off) as well as the
relevant dosage strength that has been
selected for i-DOS iIw and i-DOS w
are saved until they are changed, even
when the machine is switched off.
Topping up the detergent/ fabric
softener:
If, while intelligent dosing is selected,
the respective illuminated display
flashes and there is corresponding
information on the display panel, this
indicates that the minimum fill level has
not been reached. The content is
sufficient for approx. 3 washes.
The same detergent or fabric softener
can be added at any time. If you change
product/manufacturer, we recommend
that you clean the dispensers first.
~ Page 60
If required, adjust the basic dosage.

Base dosage

The basic dosages are:
For detergents – based on the
■
manufacturer's recommendation for
average soiling and the respective
water hardness.
F or fabric softeners – based on the
■
manufacturer's recommendation for
a medium level of softness.
Refer to the packaging label on your
detergent/fabric softener or ask the
manufacturer directly for this
information.
en
49