User's Manual of IGS-801M
Step 3: Check whether the DIN-rail is tightly on the track.
Step 4: Please refer to the following procedures to remove the
Industrial Managed Switch
from the track.
Step 5: Lightly pull out the bottom of DIN-rail to remove it from the track.
2.2.2 Wall Mount Plate Mounting
To install the
Industrial Managed Switch
on the wall, please follow the instructions described below.
Step 1: Remove the DIN-rail from the
Industrial Managed
Switch; loosen the screws to remove the
DIN-rail.
Step 2: Place the wall-mount plate on the rear panel of the Industrial Managed Switch.
25